Support belt for pregnant women

To support the stomach and relieve the back

As your baby bump grows, the area around your stomach becomes a problem zone. The weight of the baby increasingly pulls down, expectant mothers automatically compensate for this with a hollow back. Muscles and ligaments are put under great strain. The ELANEE support belt for pregnant women relieves the pressure on the back and pelvic floor. It also supports healthy posture. Bump and baby are well supported, expectant mothers feel more secure. Further benefits: Your tummy grows – and the belt grows with it. The ELANEE support belt can be adjusted to your individual requirements and extended thanks to its Velcro fastening. For support and security during and after pregnancy.

Benefits of the ELANEE support belt:

  • Relieves the pressure on the muscles of the back and pelvic floor
  • Reduces back pain
  • Supports the stomach for security and comfort
  • Extendible thanks to adjustable Velcro fastening
  • Wide back band and integrated rod for better stabilisation
  • Side elastic strips for individual adjustment
  • Breathable material for comfortable wear
  • Easy to clean, hand-washable

As the weight of the baby increases, the expectant mother’s stomach begins to hang down. Due to the increased load on the spine, this can lead to back pain and drooping in the stomach. The ELANEE Support belt for expectant mothers supports the stomach and alleviates back pain by taking some of the burden off the muscles of the back and pelvic floor. The support belt can also be worn after pregnancy to stabilise and strengthen the abdominal wall. The belt can be adjusted individually using the variable Velcro fastener and the two elastic bands. The supportive effect can be adjusted to fit personal requirements for comfort and stability. This means that the belt can be worn throughout the entire pregnancy and beyond. The ELANEE support belt is available in four sizes: S, M, L and XL

Sizing:

Measure abdominal girth according to the graphics shown here to establish the correct size. Advice: Position the measuring tape about a hand-width below the belly button diagonally towards the back.

Size S:     under 100 cm
Size M:   100-108 cm
Size L:    108-116 cm
Size XL: over 116 cm

Contents:

  • 1 ELANEE support belt for pregnant women in the selected siz
  • 1 instructions for use

Pharmaceutical registration number (PZN):

  • Size S: 12433684
  • Size M: 12433690
  • Size L: 12433709
  • Size XL: 12433715
Bild_Bauchumfang
In the course of pregnancy and with increasing weight of the child, the belly of the expectant mother is pulled down more and more. This causes additional load on the backbone. The consequences are frequent back pain and a slight pull in the abdomen. The ELANEE support belt for  pregnant women supports the belly and mitigates back pain by relieving the back and pelvic base muscles.
After childbirth, it can be used for stabilising and strengthening the abdominal wall.
It is important that you place the ELANEE support belt correctly in order to achieve an optimum supporting effect. The product images on the packaging show you the correct positioning of the belt. Please observe the following steps in the process:
Stützgürtel hinten
Open the support belt by loosening the elastic bands from the Velcro® fastener, which are fastened on the back of the belt. Place the belt on your back with the large contact surface at the spinal disc and close the belt below the belly with the right end above the left end. The arrow on  the label should point upwards.
Tip: The belt is best worn while lying on the back
Stützgürtel seite
Seal the Velcro ® fastener as snugly as it is comfortable for you. Take both elastic bands into your hands simultaneously and tighten them as evenly as possible, so that there are no folds in the fabric that could cause a pressure sensation. Fasten the elastic bands on the intended Velcro ® fastener.
Stützgürtel vorne

If you feel that the supporting belt is too taut or loose after you stand up, repeat step 1 to 5 and vary the tension in the process.

YouTube

Mit dem Laden des Videos akzeptieren Sie die Datenschutzerklärung von YouTube.
Mehr erfahren

Video laden

PGlmcmFtZSBjbGFzcz0ic2Mtd3JhcGJveC1lbGVtZW50IGltZy1yZXNwb25zaXZlIiB3aWR0aD0iOTAwcHgiIGhlaWdodD0iNDgwIiBmcmFtZWJvcmRlcj0iMCIgc2Nyb2xsaW5nPSJubyIgbWFyZ2luaGVpZ2h0PSIwIiBtYXJnaW53aWR0aD0iMCIgc3JjPSIvL3d3dy55b3V0dWJlLW5vY29va2llLmNvbS9lbWJlZC9KZm44RG5XUTJRaz9yZWw9MCZhbXA7d21vZGU9b3BhcXVlIj48L2lmcmFtZT4=

The ELANEE support belts are composed of:

  • 56 % polyamide (PA)
  • 24 % polyurethane (PU)
  • 20 % cotton (CO)

The ELANEE support belt is only suitable for hand wash and should be dried in open air without wringing or twisting. To prevent damage to the support belt, the use of chemical cleaning agents and ironing the support belt is not recommended. Please observe the cleaning and care instructions on the product in order to increase the service life of your belt.

The ELANEE support belt can be disposed of along with the household waste.
Please observe the local and regional disposal regulations in the process.

You can obtain our Support belt from:

Hebammenlogo